TRAX MANUALS > TraxDoc > TraxDoc Switches > ADDPANGRAPH - Point Graphics for T/C Panels/Zones to Specified Repository

ADDPANGRAPH - Point Graphics for T/C Panels/Zones to Specified Repository

Point Graphics for T/C Panels/Zones to Specified Repository

Note: This switch is a custom modification for a stylesheet that may not be available for your company.

Switch Set to Yes:

When set to Yes, the graphics for panels/zones will be displayed on printed Task Cards. These graphics will be stored in a TraxDoc repository that will be specified in the Config Number field.

The repository specified for the graphics for the Task Card panels/zones is TraxDoc 31597.

TraxDoc 31597 has been created.

The SGML/XML Doctype is set to Graphic Repository.

The graphics are imported to the repository specified in the Config Other field as shown below.

Note: Prior to being loaded, the graphics must be labeled with the Type Series followed by the access or panel code (i.e. 737800-1001). Both can be found via the Task Card, General tab.

A Task Card from the TraxDoc import is added to the below Work Order. The Workpack Print is printed.

The graphics for the panels appear in the Workpack Print.

Switch Set to No:

When set to No, the graphics for panels/zones will not be displayed on printed Task Cards.

The graphics are imported to the repository as shown below.

The same Workpack Print is printed again. The graphics for the panels do not appear in the Workpack Print.